Easy to Install
HDB205 1308
Available From:
HANSEN PRODUCTS (NZ) LIMITED
PO Box 809 • Whangarei • New Zealand
P:
+64 9 430 4140
F:
+64 9 430 4141
E:
info@hansenproducts.com
W:
www.hansenproducts.com
1.
Cut the pipe with pipe
cutters, knife or saw. Ensure a
square cut of pipe ends. Clean
burrs from pipe ends. Keep the
pipe end clean and as free of
scratches and imperfections as
possible.
3.
Insert the pipe into the fitting
through the Nut, White Grip
Ring & Thrust Ring until it meets
resistance at the O-Ring. Give
the pipe a firm push past the
O-Ring all the way until it hits
the final stop point.
4.
Firmly hand tighten the nut.
Use a pair of poly grips for a
further half turn past hand tight
for final tightening on 40mm
fittings and greater.
2.
Undo the nut to the last
thread, do not remove nut
from the body.
Fully Compatible
Hansen
Easy Fit
Compression Fittings are fully compatible
with all other Hansen fitting ranges.
Stop
Point
Grip
Ring
Thrust
Ring
O-Ring
The hydraulic seal is created when the pipe passes the O-ring.
Tightening the nut is to achieve pull out resistance of the pipe.
True Fit
Threaded Fittings
True Fit
Tank Fittings
Fast Fit
Tapping Saddles
Easy Fit
Poly Fittings
Superflo
TroughValves
Maxflo
Trough/Tank Valves
Foot &
CheckValves
Quick Connect
Unions
Full Flow BallValves
Leveller
Tank/Reservoir
Valve
Agriculture
Rural
Horticulture
Marine
Irrigation Domestic
Standards &Approvals
Hansen
Easy Fit
Compression Fittings in sizes 16mm
to 110mm have achieved the esteemedWaterMark
Certification for use in plumbing & drainage installations.
Certification No:WMKA21978
1 2